The K4-11W deep well electrode’s vertical length is 11 feet. A 10 foot section of 4 inch type K hard tube transitions to a soldered reducer that joins the lower 4 inch diameter portion to 2 inch diameter hollow copper type K tube 8.5 inches in length. The K4-11DW is permanently capped on the top and bottom the electrode is not filled with Calsolyte salts instead it has holes, allowing tube to fill with water. For installation, a 6 in wide hole is drilled until it reaches a water table, care should be taken to drill 12 feet into the water table to insure that the rod will be fully submerged. The K4-11DW is then lowered and after placement the hole is filled in.
Features:
- Custom Configuration Available Including Conductor Type and Length
- The K4 Rod Does Not Utilize Calsolyte
- No Hazardous Materials or Chemical Are Used In Producing The Deep Well Electrodes |